Miter Cutting Vice Jig

 Related Videos

Related Web Pages

Square up your edges or cut a beautiful bevel.

  • This is a great tool. It is used to create a 90°, 60° or a 45° angle on a piece of metal. It is perfect for filing small pieces of metal, flat.  I also use my vise to create flat ends on wire and tubing.  It can also be employed as vise to hold your metal, tubing and wire for filing, sawing or sanding.  I even use it with leather hard PMC. Rio Grande has three versions: the great quality, the economy and the three angle economy.  Please see my reviews at Rio Grande on the great quality and the three angle economy.

How To Use

  • File on this larger flat edge.
  • Insert your metal into either the 45 degree slot (top) or the 90 degree slot (bottom).   The trick here is to have one edge of your metal that is perfectly flat and level. Find the little peg or “tooth” that hangs down.
  • Put the metal in – flat side against the peg.
  • Leave a thin strip of metal hanging out the front  – that is the part that you will file square or will be beveled.
  • Evenly tighten the two top screws until the metal is almost immovable. Before tightening down fully,  ensure that the metal is flush against the peg – no gaps.
  • Check both the front and the back for fit against that ped – for the metal to be filed correctly it must be squarely in the jig.
  • Once the jig is fully tightened down (on the large, flat side of the jig) file the metal down to the steel.  Take care to keep your file flat against the jig.

Please see my information on the machinist’s vise too!  Another method for filing flat and 90° edges.

Violá – a beautiful edge!